ICW W2 Installation

ATTACH ARM TO MOUNT
Follow instructions below
for your style of mount.
IF MOUNTING TO THE
ULTRA WALL TRACK
ATTACH SLIDER TO ULTRA TRACK
• Insert slider into wall track.
• Replace the plastic cover
and small socket
head cap screw.
IF MOUNTING
ATTACH WALL PLATE TO WALL
TO THE WALL
Locate the stud and mark
the top hole, drill 11/64
pilot hole and insert #14
screw and tighten slightly.
Using a level, mark the
lower hold and drill pilot
hole, insert #14 screw
and, with the unit level,
tighten both screws.
NOTE:
#14
installing
studs,
to replace with proper
metal stud fasteners.
LAPTOP TRAY ARM INSTALLATION
LAPTOP TRAY ARM INSTALLATION
MANAGE CABLES
Follow instructions
on next page.
MOUNT ULTRA TRACK TO WALL MOUNT ULTRA TRACK TO WALL
• Remove small socket head cap screw in the top center
• Remove small socket head cap screw in the top
of the Wall Track. Remove plastic cover.
center of the Wall Track. Remove plastic cover.
• Locate the wall stud and mark the top hole of the Wall Track.
• Locate the wall stud and mark the top hole of the
• Drill 11/64 pilot hole, insert #14 screw and tighten slightly. Use a level,
Wall Track.
mark the lower holes, drill pilot holes and then insert the #14 screws.
• Drill 11/64 pilot hole, insert #14 screw and tighten
slightly. Use a level, mark the lower holes, drill
NOTE: #14 wood screws are supplied with unit. If installing into metal studs you will
pilot holes and then insert the #14 screws.
need to replace these with proper metal stud fasteners or the provided snap togglers.
All hardware used to secure track mount must have a proper countersunk head.
NOTE: #14 Wood screws are supplied with unit. If installing into
metal studs, you will need to replace these with proper metal
stud fasteners
Once you have adjusted the
slider to the desired height,
tighen down the Track Slider
using the knob on the slider
as shown.
ICW supplies
wood screws. If
onto metal
you will need
ATTACH QUICK DISCONNECT
• Remove beauty cap on
Quick Disconnect block.
• Remove screw using
3/16" hex key.
• Slide keyboard tray into
Quick Disconnect block.
• Replace screw and
tighten.
• Replace beauty cap.
IMPORTANT: DO NOT flip up tray when laptop is placed on it.
W2
Beauty cap
ADJUST SLIDER POSITION
STANDARD
Adjust slider to desired height. Tighten slider using a
W3
LAPTOP TRAY ARM INSTALLATION - 6/1/20
Screw
INVERTED