ICW ELITE 5220 Manual

RELEASE ARM RESISTANCE
Extend the Elite straight out as shown
before releasing the arm's resistance.
Be sure all equipment is mounted on
the arm before adjusting.
REMOVE MONITOR
REMOVE ARM COVERS
TOP COVERS:
Remove the long
arm covers by
unscrewing the
two 1/4" long 6-32
flathead screws
in the center of
the cover using
a Phillips head
screwdriver.
torqUe 120 inch poUnDS. Do not LooSen.
If you have any questions, please call our
customer service representatives. They will be
able to answer your installation questions.
Toll free 1-800-558-4435
Page 1 of 2
ELITE 5220 FRONT BEARING REPLACEMENT
Completely release the
resistance of the arm section
closest to the monitor. Use
the T-handle provided.
Do not USe
power tooLS to ADjUSt
Unplug and remove the
monitor by unscrewing
the adjustment knob.Save
all hardware. Remove
keyboard or secure it to
keyboard tray.
CENTER COVER:
Remove the center
cover by unscrewing
the four 3/4" long
10-24 flathead screws
using a Phillips head
screwdriver.
END COVERS:
Remove the end
covers by unscrewing
the two 3/4" long
10-24 flathead screws
using a Phillips head
screwdriver.
DANGER!
the elite arm contains high pressure gas
springs. the following cautions MUSt be
observed to avoid serious injury.
• Do not attempt to adjust the Elite arm until all
components are mounted (monitor, keyboard, etc.)
• Arm must be completely horizontal (extended)
before adjusting the arm's tension. Failure to do so will
damage the arm and void the warranty.
• never loosen or remove any of the shoulder
bolts. Doing so will cause the arm to immediately
come apart with tremendous force, and could cause
serious injury.
• If equipment requiring AC power is mounted to this unit,
have a certified electrician inspect the installation.
• Failure to install this unit according to these instructions
will void all ICW warranties. If installed incorrectly, ICW
is not liable for any damage or injury caused by the unit.
IMPORTANT
Do not use power tools to assemble or
adjust the arm. Use hand tools onLY.
REPLACE BOLT & BEARING ASSEMBLIES
Fold arm. Remove
existing bolt and bearing
assemblies beneath the
Elite foot. Replace with
new hardware provided.
ELITE 5220 BEARING REPLACEMENT - 05/02/16 pjm
40mm ID
bearing
assembly
3/8 bolt
assembly
with 3/8 ID
bearing