Precautions Concerning Sd Memory Card Operation - Panasonic FP7 Series User Manual

 When power is ON
1. Change to the PROG. mode.
2. Attach an SD memory card that houses the auto execution file "autoexec.fp7" and the
comment file "comment.fp7" for a project to the CPU unit.
3. Close the cover.
4. Until "COPY LED" flashes (approx. 5 seconds), set the RUN/PROG./COPY switch to
"COPY".
Transmission of project data is started. Once "COPY LED" starts to flash, the
transmission process continues if you let go off the COPY switch. Once transmission
is completed, "COPY LED" turns off.
KEY POINTS
Copying of a project triggered by the COPY switch does not depend on
•
settings for the card operation switch. Operation starts whether the switch
is set to CARD or ROM.

5.4.6 Precautions Concerning SD Memory Card Operation

• In an SD memory card to be used, create an "AUTO" folder, and save an auto execution file
"autoexec.fp7" and a comment file "comment.fp7".
• While copying, do not remove the SD memory card from the slot. It may cause damage to
the project.
• If the card operation switch is set to "CARD" while no SD memory card is inserted, a self-
diagnosis error will result.
• If the unit cannot access a project in the SD memory card while the card operation switch is
set to "CARD" and SD memory card operation is in progress, a self-diagnosis error will result.
5.4 SD Memory Card Operation
5-15