Mitsubishi Electric 800 Series Instruction Manual page 73

 Inverter status/operation command
The inverter status can be monitored and operation command can be given from the master.
IND PNU
H0100 HA
*1 The signal initially assigned to the terminal. Using Pr.180 to Pr.183, input signals assigned to the terminals can be changed. For the
details of Pr.180 to Pr.183, refer to the FR-E800 Instruction Manual (Function).
*2 Inverter reset (Pr.184 = "62") is disabled. Change the Pr.184 setting value to assign a function other than the inverter reset. For the details
of Pr.184, refer to the FR-E800 Instruction Manual (Function).
 Operation mode read/write
Read/write of the operation mode can be performed from the master.
IND PNU
H0100 HB
72
PPO TYPE NON-SUPPORT SPECIFICATION
Item
Inverter status
For details, refer to ZSW on page
Run command
Bit 0: Not used (0 is set)
Bit 1: STF signal (Forward rotation command)
Bit 2: STR signal (Reverse rotation command)
Bit 3: Terminal RH (High-speed operation command
Bit 4: Terminal RM (Middle-speed operation command
Bit 5: Terminal RL (Low-speed operation command
Bit 6: JOG2 signal (JOG operation selection 2)
Bit 7: RT signal (Second function selection)
Bit 8: AU signal (Terminal 4 input selection)
Bit 9: Not used (0 is set)
Bit 10: Terminal MRS (Inverter output shut off
Bit11: Not used (0 is set)
*2
Bit 12: Terminal RES
Bit13 to 15: Not used (0 is set)
Item
Operation mode
68.
*1
)
*1
)
*1
)
*1
)
External operation mode: H10
PU operation mode: H11 (When Pr.79 = "6")
Network operation mode: H14
Data definition