Mitsubishi Electric 800 Series Instruction Manual page 50

Name
Terminal RH function
Terminal RM function
Terminal RL function
JOG2 signal
ECW
AU signal


Command count
SU signal
OL signal

ESW
Terminal RUN function

Command count
*1 PZD enable and command count request can be executed.
*2 If it takes time to perform slave side processing, slave side busy status is announced since reply to the master will be delayed. During
busy status, other response data are unfixed values. When the slave side is busy, request from the master is invalid. Therefore, the same
request must be sent again. The response data of the FR-A8NP during Busy status is as follows.
ID During busy status and inverter reset
PKW 0
ZSW Bit 15 (BUSY) = "1"
PZD
Other error Bit = "0"
*3 The signal initially assigned to the terminal. Using Pr.180 to Pr.182, input signals assigned to the terminals can be changed. For the
details of Pr.180 to Pr.182, refer to the FR-E800 Instruction Manual (Function).
*4 The signal initially assigned to the terminal. Using Pr.190, output signal assigned to the terminal can be changed.
For the details of Pr.190, refer to the FR-E800 Instruction Manual (Function).
Bit
0
High speed operation command
1
Middle-speed operation command
2
Low-speed operation command
3 0: OFF, 1: ON (JOG operation selection 2)
4 0: OFF, 1: ON (Terminal 4 input selection)
5 Not used (0 is set)
6, 7 Not used (0 is set)
8 to 15 Used by the master to recognize the command response.
0 0: OFF, 1: ON (up to frequency)
1 0: OFF, 1: ON (overload alarm)
2 Not used (0 is set)
*4
3
Inverter running
4 to 7 Not used (0 is set)
8 to 15 Echo back of the command request.
During busy status and other than inverter reset
All 0 when AK = "0"
Reply data when AK ≠ "0"
ZSW Bit 15 (BUSY) = "1"
Other error Bit = inverter status data
Definition
*3
*3
*3
PPO TYPE SUPPORT SPECIFICATION
7
49