Mitsubishi Electric 800 Series Instruction Manual page 69

 PZD
Name Bit
RUN
0
signal
FWD
1
signal
REV
2
signal
SU signal 3
OL signal 4
ZSW

5
FU signal 6
ALM
7
signal
Command
8 to 14
count
 15
HIW 0 to 15
68
PPO TYPE NON-SUPPORT SPECIFICATION
0: OFF
1: ON (inverter running)
0: OFF
1: ON (forward rotation operation being
performed)
0: OFF
1: ON (reverse rotation operation being
performed)
0: OFF
1: ON (up to frequency)
0: OFF
1: ON (overload alarm)
Not used (0 is returned)
0: OFF
1: ON (output frequency being detected)
0: Inverter normal
1: Inverter alarm occurrence
Command count
The command count is an optional feature maintained by the PROFIBUS master and can range from H00 to
H7F.
The option unit copies the command count from the command it receives to the same byte offset in the
response it sends. The master may use this to synchronize commands and responses.
Not used (0 is returned)
Not used (0 is set)
Definition
• For master-to-slave messages (command request), bits 0 to 7
are not used and must be set to 0. The bit-wise data here do
not reflect Pr.190 to Pr.196 (Output terminal function
selection).
• At command response, signals are the same. Signals are not
affected by settings of Pr.190 to Pr.196 (Output terminal
function selection).