Testing The Repeatability Of The Screwdriver; Calibration Test Instructions; Overview Of The Screwdriver Speed Settings - Deprag MINIMAT-EC 320E22-00120 Operating Instruction Booklet

8

Testing the repeatability of the Screwdriver

To insure the reliability of the reported screwdriving results the user should perform a
periodic review or recalibration of the screwdriver and screwdriver electronic controller.
The interval or number of assembly cycles in between the calibration check should be
defined by the user and the users in house policy.

8.1. Calibration Test Instructions

 Testing of the screwdriver is performed using the spring table information from point
8.3. Overview of the Screw plate and Washer Spring Arrangements.
 In addition a 1 step program using the command parameter „Drive To Torque" should
be set in the AST Controller.
 The Screwdriver speed in the 1 step program should be set according to point 8.2.

Overview of the Screwdriver Speed Settings.

8.2. Overview of the Screwdriver Speed Settings
Screwdriver Series 320E – Default Speed Setting
Screwdriver Model
320Exx22-00005
320Exx22-00012
320Exx22-00025
320Exx22-00050
320Exx22-00080
320Exx22-00120
320Exx22-00200
320Exx27-0004-x
320Exx27-0014-x
320Exx27-0010/0018-x
320Exx27-0022-x
320Exx27-0024-x
320Exx27-0035-x
320Exx27-0040-x
320Exx27-0042-x
320Exx27-0050-x
320Exx27-0060-x
320Exx36-0040-x
320Exx36-0060-x
320Exx36-0090
320Exx36-0120-x
320Exx36-0180-x
320Exx36-0250
320Exx36-0280
Speed (rpm)
240
240
200
160
120
150
100
120
50
200
140
100
100
50
80
30
60
200
150
110
80
50
35
30
17