10.16
Handlebar position
10.17
Adjusting the handlebar position
Guideline
Rebound damping
Comfort
Standard
Sport
Info
Turn clockwise to increase damping; turn counter-
clockwise to reduce damping.
–
Mount protection cap
On the upper triple clamp, there are 2 holes at a distance of
to each other.
Hole distance A
The holes on the handlebar supports are placed at a distance
B
of
from the center.
Hole distance B
The handlebar can be mounted in four different positions. This
allows the handlebar to be mounted in the most comfortable
800116-10
position for the rider.
Preparatory work
–
Remove the handlebar cushion.
Main work
–
Remove screws
the handlebar and lay it to one side.
Info
Cover the components to protect them against dam-
age.
Do not kink the cables and lines.
–
Remove screws
B00375-10
–
Place the handlebar supports in the required position.
Info
The handlebar supports are longer and higher on one
side.
Position the left and right handlebar supports evenly.
–
Mount and tighten screws
Guideline
Screw, handle-
bar support
–
Position handlebar.
https://www.motorcycle-manual.com/
TUNING THE CHASSIS 10
17 clicks
12 clicks
7 clicks
1
.
15 mm (0.59 in)
3.5 mm (0.138 in)
1
. Take off the handlebar clamps. Remove
2
. Take off the handlebar supports.
2
.
M10
40 Nm (29.5 lbf ft)
A
Loctite
®
243™
41