Installing The Fork Legs; Removing The Lower Triple Clamp - Husqvarna FS 450 2019 Owner's Manual

11 SERVICE WORK ON THE CHASSIS
11.8
11.9
46

Installing the fork legs

H03252-10
V01431-11
F00429-11

Removing the lower triple clamp

https://www.motorcycle-manual.com/
Main work
–
Position the fork legs.
1
Air release screw
the front.
A
Valve of the left fork leg faces the front.
Info
Grooves are milled into the side of the upper end of
the fork legs. The second milled groove (from the top)
must be flush with the upper edge of the upper triple
clamp.
The air suspension is located in the left fork leg. The
pressure and rebound damping is located in the right
fork leg.
–
2
Tighten screws .
Guideline
Screw, top triple
clamp
–
3
Tighten screws .
Guideline
Screw, bottom triple
clamp
–
Position the brake line and clamp. Mount and tighten
4
screws .
Finishing work
–
Install the front wheel.
Preparatory work
–
Raise the motorcycle with a lift stand. (
–
Remove the handlebar cushion.
–
Remove the front wheel.
–
Remove the fork legs.
–
Remove the start number plate. (
–
Remove front fender. (
of the right fork leg is positioned to
M8 17 Nm (12.5 lbf ft)
M8 12 Nm (8.9 lbf ft)
( p. 87)
p. 43)
( p. 86)
( p. 45)
p. 51)
p. 51)