Table of Contents
Advertisement
Service And Repair
Male connector's
indexing pin
Male connector
Male connector's
retaining washer
Female connector
7. Use a pair of needle-nose pliers or long-nose locking pliers to remove the retaining washer that holds the male
connector in its socket.
8. Remove the male connector with O-ring.
9. Get the new male connector and retaining washer from the electrical connector kit.
10. Notice the small indexing pin on the back of the male connector (see Figure 33).
11. The indexing pin on the back of the connector must seat in the index hole in the base of the male connector's
socket (see Figure 34) for the connector to be correctly oriented relative to the female connector.
Wiring to UMP
Figure 32. Packer-To-Manifold Wiring Connectors
Indexing pin
Figure 33. Male Connector's Indexing Pin
Replacing the Packer-to-Manifold Wiring Connectors
045-1
41
rjpumps/fig42.eps
Advertisement
Table of Contents
