Graco 127650 Instructions Manual page 6

D TECHNICAL DATA
EN
127650 15 l/min 45 l/min 0.9 bar
4 gpm
NOTE
E INSTALLATION
FOREWORD
NOTICE
NOTICE
NO PTFE TAPE
6
1" GAS
12 gpm 13 psi 1" BSP
The wetted materials used in this device are :
stainless steel, plastic and rubber suitable for AdBlue.
The automatic nozzles are supplied ready for use.
The nozzle features SWIVEL hose-end fitting (complete
with O-ring) useful for connecting to the supply hose.
TO ENSURE PERFECT OPERATION, THE DEVICE MUST BE
USED TO DISPENSE FLUIDS WITH CHARACTERISTICS FALL-
ING WITHIN THE FOLLOWING PARAMETERS:
- Qmin .: 15 l/min / 4 gpm -- Qmax: 45 l/min / 12 gpm
- Pmin. : 1,5 bar / 22 psi - - Pmax: 3,5 bar / 50 psi
During installation, use adequate sealants, being
careful no residues remain inside the hose.
So as not to negatively affect product operation,
couple the hose-end fitting with the hose without
using tools such as pliers, etc.
Assembly will be easier if the swivel hose-end fitting
is already fitted on the nozzle.
Make sure the hoses and the suction tank are with-
out threading scale or residues which could dam-
age the nozzle and the accessories.
Apply adequate sealants on the male threads of the
connections and swivels
Do not use PTFE tape
20 mm 3.5 bar 0.8 Kg
.787 in 50 psi 1.8 lb
M0303