Komatsu WA480-8 Operation & Maintenance Manual page 317

OPERATION
START ENGINE WITH JUMPER CABLES
k k
• When connecting the cables, never contact the posi-
tive (+) and negative (-) terminals.
• Always wear protective eyeglasses and rubber gloves
when starting the engine by using the jumper cable.
• Do not bring the normal machine into contact with the
failed machine.
The sparks caused near the battery could ignite the
hydrogen gas generated from the battery, so be care-
ful not to let it happen.
• Make sure that there is no mistake in the jumper cable
connections. In the last connection (to the upper
structure frame), a spark will be caused, connect the
cable to a spot as far away from the battery as possi-
ble. (However, do not connect to the work equipment
since the current does not flow well through it.)
• Do not bring the clips in contact with other clips or
with the machine when disconnecting the jumper ca-
ble.
• Never start the engine by short-circuiting the starting
motor (jump start).
NOTICE
• The starting system for this machine uses 24 V. Accordingly, the normal machine must be equipped
with a 24 V power supply.
• The sizes of the jumper cables and clips should be suitable for the battery size.
• The battery of the normal machine must be the same capacity as that of the failed machine.
• Check the cables and clips for damage or corrosion.
• Firmly connect the clips.
• Check that the lock levers and parking brake levers (if equipped) of both machine are in LOCK posi-
tion.
• Check that each lever is in NEUTRAL position.
• To prevent damage of the electric devices of the failed machine, turn the starting switch of the failed
machine to OFF position, check that the system operating lamp is not lit, and then turn the battery
disconnect switch key to OFF position and remove it before connecting the jumper cable.
For the operating method of the battery disconnect switch, see "BATTERY DISCONNECT SWITCH
(3-123)".
PROCEDURE FOR CONNECTING JUMPER CABLES
Turn the starting switch and battery disconnect switch of the failed machine, and the starting switch of the nor-
mal machine to OFF position.
WARNING
TROUBLES AND ACTIONS
3-249