Komatsu WA480-8 Operation & Maintenance Manual page 301

OPERATION
2.
Check that the work equipment control lever is in HOLD
position.
Lock the work equipment (the pilot lamp in the switch lights
up).
3.
Set parking brake switch (1) to ON position (A).
Apply the parking brake securely.
4.
Turn the starting switch to OFF position and stop the en-
gine.
Remove the starting switch key.
5.
Set the frame lock bar to LOCK position (L).
6.
Lock the front frame and rear frame.
7.
Set chocks at the front and rear of the tires to prevent the
machine from moving during transportation.
8.
Tie one end of each chain or wire rope of appropriate
strength to the tie-down holes as shown in the figure, and
secure the machine.
Secure the machine so that it will not move during trans-
portation.
In particular, fix the machine securely to prevent it from
slipping sideways.
Keep the securing tools off the machine.
9.
Stow the antenna, etc.
TRANSPORTATION
3-233