Komatsu WA480-8 Operation & Maintenance Manual page 184

EXPLANATION OF COMPONENTS OPERATION
NOTICE
While removing the ashtray, if it is stuck in the console
cover and hard to be removed, open lid (A) of ashtray, then
hold the ashtray body (B) and twist it to remove.
If you hold lid (A) of ashtray and twist it, the ashtray may
break.
POWER SUPPLY OUTLET
24 V power supply
NOTICE
Do not use this as a power supply for 12 V equipment.
This will cause failure of the equipment.
When cigarette lighter (1) is removed, its socket can be used
as a 24 V power supply.
The capacity is 85 W (24 V x 3.5 A).
REMARK
Use 24 V power source while engine is running.
12 V power supply
Power supply take-out (2) can be used as a 12 V power supply.
The capacity is 144 W (12 V x 12 A).
Power supply take-out (3) (if equipped) can be used as a 12 V power supply.
The capacity of 12 V power supply is 144 W (12 V x 12 A).
The total capacity of power take-outs (2) and (3) is 144 W.
REMARK
Use 12 V power source while engine is running.
FUSE
NOTICE
When replacing the fuse, be sure to turn the starting switch to OFF position and, after confirming that
the system operating lamp is not lit, set the battery disconnect switch key to OFF position.
The fuses protect the electrical component and wiring from burning out.
If the fuse becomes corroded, or looks white powdery, or the fuse is loose in the fuse holder, replace the fuse.
Replace the fuse with the one of the same capacity.
Should the fuse is blown, investigate the cause and take necessary actions.
3-116