NOTE:
Before working inside your computer, read the safety information that shipped with your computer and follow the
steps in
Before working inside your
inside your
computer. For more safety best practices, see the Regulatory Compliance home page at
regulatory_compliance.
Topics:
•
Prerequisites
•
Procedure
Prerequisites
1. Remove the
base
cover.
2. Remove the battery.
3. Follow the procedure from step 1 to step 4 in
Procedure
1. Open the latches and disconnect the I/O-board cable, power and volume-buttons board cable, and sensor-board cables from
the I/O board.
Figure 45. Disconnecting the cables from the IO board
1. I/O-board cable
3. sensor-board cable
5. power and volume-buttons board cable
2. Remove the two screws (M2x3) that secure the I/O board to the palm-rest and keyboard assembly.
26
Removing the I/O board
Removing the I/O board
computer. After working inside your computer, follow the instructions in
"Removing the hard
2. latch
4. I/O board
drive"(Only for computers shipped with a hard drive).
13
After working
www.dell.com/