Table of Contents
Advertisement
NOTE:
Before working inside your computer, read the safety information that shipped with your computer and follow the
steps in
Before working inside your
inside your
computer. For more safety best practices, see the Regulatory Compliance home page at
regulatory_compliance.
Topics:
•
Prerequisites
•
Procedure
Prerequisites
1. Remove the
base
cover.
2. Remove the battery.
3. Remove the
wireless
card.
4. Remove the
display
assembly.
5. Remove the
display
panel.
Procedure
1. Peel the tapes and remove the antenna cables from the routing guides on the display back cover.
Figure 68. Removing the antenna cables
a. antenna cables (2)
b. tape
c. hinge cover (2)
2. Remove the two screws (M2x2.5) and four screws (M2.5x2.5) that secure the display hinges to the display back-cover and
antenna assembly.
3. Lift the display hinges off the display back-cover and antenna assembly.
Removing the display hinges
computer. After working inside your computer, follow the instructions in
After working
www.dell.com/
Removing the display hinges
35
65
Advertisement
Table of Contents
