Table of Contents
Advertisement
Commercial FT, Condensate Trap Assembly Instructions
1. The discharge hose 'end adapter'.
2. Hose adapter.
3. Hose clamps (3).
4. Transparent discharge hose.
5. The condensate trap (pre-assembled with cap & fl oat).
6. Inlet Hose, 2.5" x .75".
7. Adapter, .75" barb x 1.0" NPT, PVC.
8. Mounting bracket (top half).
9. Mounting bracket (bottom half) with the velcro strap.
10. Screws (2).
Thread item 7 onto the discharge pipe at the
back of the unit. Do not over tighten.
Place the two mounting brackets together
and fasten them to the unit just below
the condensate discharge hose using
the 2 screws as shown.
Assemble items 1 thru 6 to make
the condensate trap sub-assembly.
There will be a remaining hose clamp.
Place it over the inlet hose and leave it loose.
With the 3rd hose clamp on the inlet hose, press the inlet side of the condensate trap assembly onto the PVC
adapter. The condensate trap will fi t into the bracket as shown below. Tighten the third hose clamp suffi ciently. Re-
check all hose clamps.
Use the velcro strap to fasten the condensate trap into the bracket assembly as shown below.
Run the Molex connector of the condensate trap sensor into the closest wiring grommet as shown. Reach into the
access panel and fi nd the Molex connector on the inside (blue and blue/white wire) and connect them.
Attach the condensate disposal system of your choice to the 'end adapter'. Check for condensate leakage when
the unit is running.
To condensate
disposal system
Figure 17. Condensation Trap Assembly
The mounting brackets overlap and are
FT
800.900.9276 • Fax 800.559.1583
20 Industrial Way, Rochester, NH 03867 • 603.335.6300 • Fax 603.335.3355
1869 Sismet Road, Mississauga, Ontario, Canada L4W 1W8 • 905.238.0100 • Fax 905.366.0130
www.Laars.com
3
5
4
2
1
The Completed View
Document 4378
8
7
6
9
Kit Components
(Customer Service, Service Advisors)
(Applications Engineering)
Page 37
NPT discharge
pipe on boiler
10
Page 1 of 1
Advertisement
Table of Contents
