Setting From Windows Or Unix Operating Systems - Xerox DocuPrint Network Laser Printers Information Manual

Setting DEFAULT GATEWAY at the Control Panel
Setting from
Windows or Unix
Operating Systems
2-20 DocuPrint Technical Information Guide
Perform these steps to enter the Default Gateway using
telnet from a Windows or Unix OS. Some DocuPrint
network printers do not support telnet. For these printers,
enter the Default Gateway from the Control Panel as
described in the previous section.
Telnet only works if the device is on the same subnet as the
host (i.e. computer or workstation).
1 Open a telnet session.
Windows: Open a MS-DOS window, type telnet
x.x.x.x[Enter], where x.x.x.x is the IP address
Unix: Type telnet hostname in a shell
2
Type ![Enter] and then yes[Enter] to enter monitor mode.
3 Select the Network Protocols Menu, N [Enter].
4 Select the TCP/IP Options Menu, T [Enter].
5 Select the Engine Options Menu, E [Enter].
6 Type y [Enter].
7
Select Default router (gateway), g [Enter].
8 Enter the new Default Gateway address, [Enter].
9 Select X [Enter] to exit this menu or end the telnet
session.