Display/Set Parallel Port Parms And Status - Xerox DocuPrint Network Laser Printers Information Manual

Display/set parallel
port parms and
status:
Command [?,C,D,E,F,H,I,L,N,P,Q,R,S,Z,*,+] --> p
Parallel port 1 status: (NOT_CONNECTED)
Current Parallel port config:
mode setup/strobe (us) console/test page
bidirection
Standard 2.7
Parallel port mode:
1 (Standard)
2 (Fifo-ACK)
3 (Fifo-BUSY)
<enter> (don't change/continue)
Select data-setup/strobe-width (in microsec)
1 (2.7)
2 (5.4)
3 (8.1)
4 (10.8)
<enter> (don't change/continue)
Select parallel console/test page type
1 (PostScript)
2 (Ascii text)
<enter> (don't change/continue)
Enable Bidirection Interface ?
1 (No)
2 (Yes)
<enter> (don't change/continue)
New Parallel port config:
mode setup/strobe (us) console/test page
bidirection
Standard 2.7
Appendix A: Telnet and NBMON command mode options
Monitor Menu:
PostScript Disabled
PostScript Disabled
A-11