Definitions - Magni Gyro M-24 Maintenance Schedule

045-00-24_A M24 MAINTENANCE SCHEDULE
Issue A
All maintenance carried out in connection with a particular check should be certified on suitably
referenced worksheets and included in the gyroplane records. These worksheets must be cross-
referenced in the appropriate log book(s) giving general details of the additional maintenance
carried out.
2.11

DEFINITIONS

Throughout the schedule the following terms and abbreviations have the stated definitions:
Service/Lubrication (Service/LUB)
The term 'Service or Lubrication' requires that a component or system should be serviced and/or
replenished as necessary with fuel, oil, grease, water, oxygen, etc., to a condition specified in
the appropriate maintenance manual. The term 'service' may also be used to require filter
cleaning or replacement.
Inspect (INSP)
An 'Inspection' is a visual check performed externally or internally in suitable lighting conditions
from a distance considered necessary to detect unsatisfactory conditions/discrepancies using,
where necessary, inspection aids such as mirrors, torches, a magnifying glass etc. Surface
cleaning and removal of detachable cowlings, panels, covers and fabric may be required to be
able to satisfy the inspection requirements.
Operational Check (OP/C)
An 'Operational Check' is a test used to determine that a system or component or any function
thereof is operating normally.
Functional Check (F/C)
A 'Functional Check' is a detailed examination of a complete system, sub-system or component
to determine if operating parameters are within limits of range of movement, rate of flow,
temperature, pressure, revolutions per minute, degrees of travel, etc., as specified in the M24
(M24C) maintenance manual. Measured parameters should be recorded.
Check (CHK)
A 'Check' is the verification of compliance with Magni Gyro Srl recommendations.
Continuing Airworthiness
Means all of the processes ensuring that, at any time in its operating life, the gyroplane complies
with the airworthiness requirements in force and is in a condition for safe operation.
Page 7