Table of Contents
Advertisement
2
RESPONSIBILITIES AND STANDARDS
2.1
OWNER/OPERATOR RESPONSIBILITIES
Owners/operators are responsible for the accomplishment of the maintenance prescribed in
this schedule.
2.2
CERTIFYING PERSONS RESPONSIBILITIES
Certifying persons must use their engineering skill and judgment in determining the depth of
inspection needed and other matters which could affect the airworthiness of the gyroplane.
In order to claim any alleviation on subsequent inspections, the gyroplane maintenance
records must record the extent of previous inspections upon which the alleviation is based.
Certifying persons are responsible for recording in the appropriate log book or worksheet,
any defects, deficiencies or additional maintenance required as a result of implementation of
the schedule.
2.3
GENERAL INSPECTION STANDARDS
The general inspection standards applied to individual task inspections must meet the
recommended standards and practices of Magni Gyro Srl and are published in M24 (M24C)
maintenance manual.
In the absence of general inspection standards, refer to other standards recommended by
Magni Gyro Srl or Authorities' recommended standard s and practices.
Inspections may be carried out without component removal or dismantling unless considered
necessary or where required by the schedule.
2.4
AIRWORTHINESS LIFE LIMITATIONS (RETIREMENT/SCRAP LIVES)
Airworthiness life limitations shall be those published by the Authorities and those defined in
Section 7 of this report. Airworthiness life limitations shall be recorded according to local
requirements.
2.5
AIRWORTHINESS DIRECTIVES
All applicable Airworthiness Directives and Mandatory Permit Directives, issued by the
relevant Authorities, must be complied with.
Compliance with Airworthiness Directives and Mandatory Permit Directives shall be recorded
accordingly with local requirements.
045-00-24_A M24 MAINTENANCE SCHEDULE
Issue A
Page 5
Hide quick links:
Advertisement
Table of Contents
