Appendix E Setting Default Gateway At The Control Panel - Xerox 701P91273 Installation Manual

Appendix E Setting DEFAULT GATEWAY at the Control Panel

1. Press On Line button on the Control Panel . Be sure the light next to it is OFF
2. Press
displayed.
3. Press Up+ until
press Enter.
4. Press Up+ until
5. Press Up+ until
6. Press Up+ until
7. To set each digit of the subnet mask, press Up+ to increase the digit value.
Press Down- to decrease the digit value. When each digit is correct, press Next
button to move on to the next digit.
8. The Next button wraps around the display without setting the value if an error is
made. After the complete IP address is displayed correctly, press Enter. The
Default Gateway address is now set.
9. Reset Printer to have the new settings take effect.
XPrint UNIX SYSTEM PRINTER DRIVER INSTALLATION
. The ON-LINE message disappears and TOP MENU is
Menu
<COMMUNICATIONS>
<NETWORK SETUP>
is displayed and then press Enter.
<TCP/IP>
<GATEWAY>
appears on the Display Panel and then
is displayed and then press Enter.
is displayed and then press Enter.
15-5