Clutch Master Cylinder - Suzuki GSF1200SK6 Setup Manual

Insert the choke cable into the hole of lower housing.
Insert the choke cable end into the recess in the choke
lever.
NOTE:
Before installing the cable, grease its cable
end.
A: Choke cable end
B: Hole
C: Lower housing
D: Choke lever
Insert the boss of lower housing into the hole on the
handlebars.
Install the left switch upper housing and tighten the left
switch assembly with the two screws.
Fasten the choke cable holder on the front screw.
A: Boss
B: Hole
C: 5 × 44 mm screw
D: 5 × 25 mm screw
E: Cable holder

CLUTCH MASTER CYLINDER

Install the clutch master cylinder onto the handlebars.
Align the dot mark on the handlebars with the master
cylinder-to-holder fitting surface.
Tighten the master cylinder mounting bolts to the
specified torque.
Clutch master cylinder mounting bolt:
NOTE:
To install the holder correctly, first tighten the
C of the upper side with specified torque
bolt
and then tighten the bolt
A: Holder
B: Clutch master cylinder
C: 6 × 22 mm flange bolt
D: 6 × 22 mm flange bolt
E: Dot mark
9
10 N·m (1.0 kgf-m)
D of the lower side.