Table of Contents
Advertisement
Challenge Standard Fixed Gages
These fixed gages with pre-cut hole spacings fit on the
side guide in place of the movable stops. To use, simply
loosen the set screws holding the adjustable stops and
slide them out of the way. They may either be removed
from the backgage or slid to the extreme right end of
the scale where they will be out of the way and cannot
become lost. Slide the fixed gage into the backgage
from the left end, making sure that the slanted lead for
the stops is to the left. Position the gage so that the
right end lines up with the dimension on the scale for
the centerline of the first hole to be drilled. Tighten in
place with the two set screws. Actual operational use
of the stops on the fixed gage is the same as using the
adjustable stops.
F.330-J/APR 97
FIXED GAGES AND EXTRA STOPS
These fixed gages are available from stock in the
following standard types:
22-stop Gage, 1/2" centers (for multi-ring binders)
25-stop Gage, 3/8" centers
25-stop Gage, 1/4" centers
34-stop Gage, 1/2" centers
46-stop Gage, 3/8" centers
50-stop Gage, 1/4" centers
Special fixed gages with any desired hole spacing can
also be supplied. In ordering be sure to specify the
number of stops (holes) and the hole spacing. A sample
of the job to be drilled or a drawing of the hole spacings
is helpful. Also, specify machine model and serial
number.
Extra Stops
In addition to the stops supplied with each Challenge
Paper Drilling Machine, extra stops are available at a
nominal price.
Item
Stop
Set Screw
Cat. No.
S-1611-1
H-6938-102404
25
Advertisement
Table of Contents
