106
Finishing tab in the job parameters window
Parameter
Finishing
Apply these settings to specify how to finish your job.
Option
Output tray
OCT (Offset catch
tray)
SCT (Standard
catch tray)
Standard Top Tray
Standard Stacker
Tray
Booklet Maker
Tray
Standard TriFold
Tray
Description
Lists the available finisher options. This list depends on the
modules that are installed on the printer.
Provides the following options:
●
OCT
SCT
●
Standard Top Tray
●
Standard Stacker Tray
●
Booklet Maker Tray
●
●
Standard Trifold Tray
Advanced Top Tray
●
●
Advanced Stacker Tray
Professional Top Tray
●
●
Professsional Trifold Tray
Professional Booklet Maker Tray
●
Provides the following option:
Specify when to offset copies of your job. The default is set
to 1. If you do not want to use an offset between sets, clear
this check box.
Note: If the page size is larger than A3 (standard or
custom), the Offset check box is not available.
Standard output tray with no finishing options available.
Provides the following options:
Punch—The values vary according to the type of punch
●
unit connected. The number of holes is 2.
Z-Fold half sheet
●
Provides the following options:
●
Staples—The position of the staples on the page.
Punch—The values vary according to the type of punch
●
unit connected. The number of holes is 2.
Z-Fold half sheet
●
Provides the following options:
●
Booklet Staple
Provides the following options:
●
Tri-fold Z
Tri-fold C
●
Chapter 11—Job parameters