Page 1
TS345-01/02 The -01 high back chair is Part Description Size Quantity shown on these pages. The -02 mid back assembles following the same manner. Hex head screw 2-3/4" Lock washer 1/4" dia. Phillips head screw 1" Backrest Allen wrench Seat...
Page 2
Insert cylinder into base Assemble cylinder cover With base resting on floor, insert Slide cylinder (A) up through cylinder (B) cylinder as shown. (see fig 1). With cylinder (A) engaged with cylinder (B), slide cylinder (C) down over cylinders (A and B) (see fig 2). Refer to fig.
Page 3
Finger tighten 4 bolts (H1) with Place backrest in a forward washers (H2) through arms and leaning position. Finger tighten into the sides of the seat, as 2 bolts (H1) with washer (H2) shown. through the arms into the back- rest as shown.
Need help?
Do you have a question about the TS345-01 and is the answer not in the manual?
Questions and answers