Xantrex XTR 850 WATT SERIES Operating Manual page 142

Remote Operation
Multiple Power Supply Setup
5-16
Master Setup:
◆ Configure the master XTR by selecting the communication interface
you wish to use to communication with the Master and follow the
setup instruction in this chapter.
Important: If either RS-232 or RS-485 are used for communication with the
master, the data rate must be configured for 9600 bps to properly communicate
with the slave units.
Slave Setup:
1. Turn the 9-position mode control to PGM.
rE is displayed in the output voltage display.
2. Turn the rotary Adjust/Enter control to select SLA and press the Enter
button.
3. Set a unique address. See "Multichannel Address Setting" on page 5–
21.
M370046-01