Application
2
Standard Roll Feed
2.1
The Tasks of a Roll Feed
2.2
The Hardware Needed
BTV
3 x 400 to 480V
50/60Hz
DOK-SUPPL*-BTV04*ELW**-AW01-EN-P
It is the task of a roll feed to transport material (sheet-metal, wiring and so
on) under a press, cutter or stamper. The material may only be trans-
ported if the stamping or cutting tool is open. The synchronisation be-
tween feed and press is controlled with an external signal (feed area)
which signals the position of the press.
Fig. 2-1: Roll Feed
The Indramat system for a standard roll feed with ELC control is made up
of the following hardware components:
Drive controller DKC21.3
Servo motor MKD o MHD
BTV04 operator terminal
DKC
mains
Fig. 2-2: Block diagram
Standard Roll Feed
Indramat
meas.wh.
does not
supply
wheel
gearbox
MMD/
M
MHD
Imp/rev.
Abb_022_ELW_en
2-1