M-Set: Timeout; M-Set: Lock; M-Set: Sys; M-Set: Pos 1-15 (Igntime) - Explo X2 Wave Flamer Manual

3.2.6 M-Set: TIMEOUT

Allows you to change the value of time, after which the device stops playing the show, if it does not
receive a synchronisation signal from the transmitter (set in steps of seconds from 1 to 99, standard
30). The timeout should never be below 6, since the transmitter send the synchronisation signal only
every 5 seconds.

3.2.7 M-Set: LOCK

Allows you to lock the receiver menu. Also allows you to set the code to unlock the menu.

3.2.8 M-Set: SYS

Allows you to change the System-adress of the receiver.

3.2.9 M-Set: Pos 1-15 (Igntime)

This value should not be changed (a future Update will make use of this menu item, standard 40).

3.2.10 M-Set: Pos 16-30 (Igntime)

This value should not be changed (a future Update will make use of this menu item, standard 340).

3.2.11 M-Set: Pos 1-15 (20ms pulse)

This value should not be changed (a future Update will make use of this menu item, standard OFF).

3.2.12 M-Set: pos 16-30 (20ms pulse)

This value should not be changed (a future Update will make use of this menu item, standard ON).

3.2.13 M-Set: CENTER

Allows you to change the position of the middle (Position 8, 0°) a few degrees to the right or left
(Standard acc. to factory settings). This may be useful if the device cannot be placed completely
horizontal.

3.2.14 M-Set: Invert

If this is set to "ON", all positions (see 4.1.2) are mirrored (15↔1, 14↔2, 13↔3, 12↔4, 11↔5,
10↔6, 9↔7, 8=8).

3.2.15 M-Set: Pos MIN

Allows you to set from which position (1 to 15) the device may use certain sequences. Positions
below the set one, will not be used.
Wave-Sequences are exempt from this.
WARNING

3.2.16 M-Set: Pos MAX

Allows you to set from which position (1 to 15) the device may use certain sequences. Positions
above the set one, will not be used.