Preparing The Unit; Disconnecting The Unit From Power - Cornelius Energize 1 HC Installation And Service Manual

4

Preparing the unit

DANGER!
Risk of personal injury and equipment damage due to non-compliance with safety information!
Failure to observe the safety information will result in a risk of bringing about operating conditions at the unit,
which may cause personal injury or equipment damage.
• Please always strictly observe all safety measures and information/instructions; see chapter 1.
This chapter describes the tasks that may be required before carrying out any actual maintenance or repair work.
DANGER!
You may only continue working on the unit if the unit carries no voltage.
If the unit still carries a voltage after you have disconnected it from power, this indicates a defect. Resolve this
defect before continuing the checks/inspections or any work.
4.1

Disconnecting the unit from power

Prerequisites
The tower has been shut down.
Required tools/materials
Undercounter cooler cable diagram
Tower operator
manual
Multimeter
1. Turn the compressor switch (Fig. 4/1) to position "0".
2. Turn the circulation pump switch (Fig. 4/2) to position "0".
3. Turn the carbonator pump switch (Fig. 4/3) to position "0".
4. Pull the mains plug out of the earthed socket.
ATTENTION!
Risk of death from electric shock!
The mains plug may still have residual current.
• Wait a minimum of 1 minute before continuing work on the unit.
ATTENTION!
Risk of equipment damage!
A direct "low ohm" discharge may cause equipment damage.
• Discharge the components properly.
Installation and service manual Undercounter cooler
Energize 1 HC
10
References
See the document "Tower operator manual"
ID/
reference
220046687
Document no:
various
Various
Qty/ Comment
amount
1 see chapter 10.2
1
1 Safety category CAT II
Fig. 4
Fig. 5
Cornelius Deutschland GmbH
Preparing the unit
1 2 3
Document no. TD1001100
Version 03/08/2018, Index 2