Tension The Springs; Locking; Doors With Openers - B&D Roll-A-Door 2 Series Installation Instructions Manual

Roll-A-Door Series 2 installation instructions
®

2.5 tension the springs

WARNING! Once the packaging containing the door roll is cut, the door will have a strong tendency to
rise and revolve. If uncontrolled, the rapidly unrolling door could cause damage or injury.
a) Ensure that the bottom rail is at the 9 o'clock
position as shown in Step 2.4.
b) Ensure both "U" bolts are tightened, then -
1. Rotate the door approximately 2 complete
turns in a forward direction to apply tension.
Do not let go as the springs are now tensioned.
See arrow in Fig 2.5.1.
2. Hold the door firmly, NOW cut the plastic
wrap along the bottom rail (taking care not to
damage door surface).
c) Pull the curtain down slowly into the guides below
the head stop.
d) Fit bottom rail stops
provided. Allow the door to rise and rest against
head stops.
e) Test the door operation by moving it up and
down. The curtain must feed in smoothly without
F ACE P L AT E
bumping - adjust lead in as required Step 2.4.2.

2.6 locking

HOOK
2.6.1 centre locking bar doors with openers (R2W & R2L)
LACERATION: Wear appropriate gloves as
some edges of the door are very sharp.
If the door is going to be fitted with an opener, the locking bars, retainers and locking bar covers do not need to
be installed. Proceed as per below then move to section 2.7.
a) Fit faceplate F
the right as possible. Use adhesive tape on outside to hold in position (Fig 2.6.1).
b) Attach the lock assembly
Do not over tighten the screws (Fig 2.6.2).
c) Ensure a clean and dry guide surface. Wipe guide with clean rag.
LOCK CORRUGATION
Fig: 2.6.1
E using self locking nuts
LOCK ASSEMBLY
to outside of door where the hook will latch onto curtain edge, then slide faceplate as far to
F to the faceplate
THIS END FIRST
F
Fig: 2.5.1
F from the inside, using the mounting screws
F ACE P L AT E
HOOK
Fig: 2.6.2
head stop
E
rail stop
locking
G and washers.
F
G
F
LOCK ASSEMBLY
11
self
nuts