Honeywell HON 512 User And Maintenance Manual page 35

Requirements for the
personal protective gear
Workplace
requirements
HON 512 with HON 650 pilot user manual
Personnel Responsibilities
Tasked with the installa- Set-up
tion
Mechanical maintenance Involving mechanical parts:
personnel
▪ Fault finding
▪ Maintenance
▪ Repairs
Inspector Safety check
Tasked with the disposal Disposal of the device
Any persons handling the device must be equipped with the following personal protective
gear:
Task
Start-up, operation (including partial),
cleaning, maintenance, search and remedy
of errors
To ensure the safe handling of the device, the personnel must remain at the
workplaces intended for performing their tasks.
The workplaces for performing the various tasks are at the following locations:
Task
▪ Installation
▪ Start-up
▪ Set-up
▪ Maintenance, repairs
▪ Decommissioning
Required qualification
▪ Professional training and experience
operating pressure equipment and
systems
▪ Knowledge of the relevant standards
and regulations
▪ Ability to identify and avoid dangers
autonomously
▪ Professional training and experience
operating pressure equipment and
systems
▪ Knowledge of the relevant standards
and regulations
▪ Ability to identify and avoid dangers
autonomously
Qualified inspector with adequate
knowledge of gas pressure regulators
▪ Professional training and experience
with the disposal of pressure
equipment and systems
▪ Knowledge of the relevant standards
and regulations
▪ Ability to identify and avoid dangers
autonomously
Required personal protective gear
▪ Industrial protective helmet
▪ Protective clothing
▪ Safety harness
▪ Ear protection
▪ Safety boots with protection for electrostatic dis-
charge (ESD)
▪ Safety goggles
▪ Safety gloves
Workplaces
All around the device, depending on the task
Safety
35