Intended Use - Honeywell HON 512 User And Maintenance Manual

2.1

Intended use

Intended use
Limitations of use
HON 512 with HON 650 pilot user manual
Gas pressure regulators consisting of an HON 512 actuator assembly combined with an HON
650 pilot can be used to maintain the outlet pressure constant within set limits within a gas
regulating line regardless of gas discharge changes and inlet pressure changes. These gas
pressure regulators work on a purely pneumatic basis. Typical applications include gas regu-
lating lines in transfer stations, transmission networks, power stations, and industrial facilities.
Due to their control dynamics, the gas pressure regulators are used especially for gas turbine
circuits. The gas pressure regulators are suitable for use with natural gas or dry,
non-aggressive industrial gases.
Note: The gas pressure regulator's operating limits concerning the gas, the operating pres-
sure, and the operating temperature can be found either on the nameplates affixed to the
device or in the device's technical specifications.
The use under different operating conditions must be coordinated in consultation with the
manufacturer.
Please observe the following limitations of use:
▪ Do not use the device for any media other than those mentioned in the intended use or
those discussed with and approved by the manufacturer.
▪ Do not use the device in any installation position other than the one documented in
this user manual.
▪ Do not use the device against the direction of flow specified on the device and in the
user manual.
▪ When replacing defective parts, only use original spare parts or manufacturer-approved
standard parts.
▪ Do not attempt to modify or remodel the device on your own.
Description
9