Reassembling The Pilot - Honeywell HON 512 User And Maintenance Manual

Next task
HON 512 with HON 650 pilot user manual
Figure
Proceed as follows:
Reassembling the pilot (see page 139)
Step Description
5 Insert the filter insert (1), with the opening
facing downwards, into the body.
6 Take the base plate. Replace the O-ring
with a new, greased O-ring.
7 Put the base plate on the body. Tighten the
nuts (1) and washers (2) for the base plate
(3) in a criss-cross sequence. Observe the
tightening torque information provided in
the table before this section.
8 Unscrew the fittings and replace the
sealing rings (1) with new, greased ones.
9 Install the greased fittings back in place.
Observe the tightening torque information
provided in the table before this section.
Maintenance
138