Mya-Mina/Lina Mounting Yoke - Meyer Sound LINA Operating Instructions Manual

MYA-MINA/LINA MOUNTING YOKE

The MYA-MINA/LINA mounting yoke flies up to three LINA
loudspeakers from a single hanging point using a C-clamp or
equivalent (Figure 30), or pole-mounts up to two LINA
loudspeakers with a third-party pole-mount adapter (see
"Pole-Mounting LINAs with the MYA-MINA/LINA" on page 30).
For flown applications, the yoke supports up to 30° of uptilt
and severe downtilts of up to 90°. For flying larger arrays, the
MG-MINA/LINA/750-LFC grid is recommended; for smaller
profile applications, the MUB-MINA/LINA U-bracket is
recommended.
Figure 30: MYA-MINA/LINA with MPA-3 Adapter, Three LINAs, and
third-party clamp
CAUTION: The MYA-MINA/LINA's mounting
!
bracket at the top of the yoke has one 1/2-inch
center hole that is rated for flown applications. The
smaller two center holes and four corner holes should
only be used for attaching to pole-mount adapters.
NOTE: For complete information about
configuration and load ratings for the MYA-
MINA/LINA, as well as for other rigging accessories,
refer to the MG-MINA/LINA/750-LFC Assembly Guide
(PN 05.207.101.02) available at
MYA-MINA/LINA Bracket Options
The yoke includes two bracketing options: the MPA-2 for
attaching to two cabinets (Figure 31 and Figure 34), and the
MPA-3 (Figure 30, Figure 32 and Figure 33) for attaching to
one or three cabinets. The bracket options allow the yoke to
attach near the center of gravity for the loudspeakers. The
brackets bolt directly to the LINA end frames with the M6 bolts
and washers included with the yoke kit. For attaching to the
yoke, the brackets include a center/pivot hole and three
pinning holes to yield a wide range of uptilt and downtilt
angles for the loudspeakers.
MPA-2 Bracket
When suspending two LINA cabinets with the
MYA-MINA/LINA mounting yoke, use the MPA-2 bracket and
attach it to the bottom cabinet (Figure 31).
Figure 31: MPA-2 bracket
MPA-3 Bracket
When suspending one or three LINA cabinets with the
MYA-MINA/LINA mounting yoke, use the MPA-3 bracket
(Figure 32). When suspending three cabinets, attach the
bracket to the center cabinet (Figure 33).
LINA OPERATING INSTRUCTIONS
www.meyersound.com.
29