Appendix D: Lina Uw Rain Hood And Shield Attachment; Parts List; Ultra Weather Protect Rain Hood And Uw Shield Installation - Meyer Sound LINA Operating Instructions Manual

APPENDIX D: LINA UW RAIN HOOD AND SHIELD ATTACHMENT

PARTS LIST

The Ultra Weather Protection LINA Rain Hood includes the following parts:
LINA Rain Hood with attached gasket (PN 45.268.035.03)
•
LINA UW Rain Hood Shield (PN 64.268.129.01)
•
4 pan head Phillips 6-32 x 0.5-inch stainless-steel screws (PN 101.031)
•

ULTRA WEATHER PROTECT RAIN HOOD AND UW SHIELD INSTALLATION

The LINA rigid removable rain hood plus UW rain hood shield are easily attached and removed with the included four screws
(Figure 48).
Figure 48: LINA with Rain Hood and UW Shield (left) and Inside Rain Hood view of Cable Routing over Inner Wall (right)
1. Attach any required cables to the LINA loudspeaker.
2. Carefully route the cables, so that they wrap over and down the inner rain hood wall (see Figure 48, right), and exit through
the slot.
3. Attach the rain hood to the user panel and loosely secure it to the center of the panel with its four 6-32 x 0.5-inch screws.
4. Engage 2-3 threads on the upper- and lower-left screws. The cables should exit to the left when viewing from the rear of the
loudspeaker. Do not cross the cables at the rain hood opening (see Figure 49, right).
5. Route the cables up and over the top of the rain hood between the shield and the rain hood. Do not cross the cables (see
Figure 49, left).
6. Angle the shield and hook the slots in the L-shaped UW shield over both upper- and lower-left screws (when facing the rear
of the loudspeaker, see Figure 49, right).
LINA UW RAIN HOOD AND SHIELD ATTACHMENT
Do not cross cables
47