Chapter 4: Mounting Ultra Xp Loudspeakers; Important Safety Considerations; Ultra Xp Loudspeaker Rigging Options - Meyer Sound ULTRA XP Operating Instructions Manual

CHAPTER 4: MOUNTING ULTRA XP LOUDSPEAKERS

IMPORTANT SAFETY CONSIDERATIONS

When installing Meyer Sound loudspeakers, the following
precautions should always be observed:
All Meyer Sound products must be used in accordance
■
with local, state, federal, and industry regulations. It is
the owner's and user's responsibility to evaluate the reli-
ability of any rigging or mounting method for their appli-
cation. Rigging should only be carried out by
experienced professionals.
■ Use mounting and rigging hardware that has been rated
to meet or exceed the weight being hung.
■ Make sure to attach mounting hardware to the building's
structural components (studs or joists), and not just to
the wall surface. Verify that the building's structure and
the anchors used for the installation will safely support
the total weight of the mounted loudspeakers.
■ Use mounting hardware appropriate for the surface
where the loudspeaker will be installed.
Make sure bolts are tightened securely. Meyer Sound
■
recommends using Loctite
cables.
Inspect mounting and rigging hardware regularly. Imme-
■
diately replace any worn or damaged components.
®
on bolt threads and safety

ULTRA XP LOUDSPEAKER RIGGING OPTIONS

Ultra XP loudspeakers include the following rigging options.
Loudspeaker
UPJ-1XP ultracompact
VariO loudspeaker
UPJunior-XP ultracompact
VariO loudspeaker
UPM-1XP ultracompact
wide coverage loudspeaker
UPM-2XP ultracompact nar-
row coverage loudspeaker
UMS-1XP ultracompact
subwoofer
NOTE: The UMS-SM subwoofer is a version of
the UMS-1XP subwoofer with threaded end
plates for single-mount configurations with the
UMS-SM U-bracket. The UMS-SM end plates are
factory-installed with the U-bracket and not available
as an upgrade option for the UMS-1XP.
Rigging
Heavy-duty, corrosion-resistant
6061-T6 aluminum end plates
with threaded M8 attachment
points for QuickFly rigging
options, basic eyebolt rigging,
and third-party pole assemblies
Heavy-duty, corrosion-resistant
6061-T6 aluminum end plates
with threaded M8 attachment
points for QuickFly rigging
options, basic eyebolt rigging,
and third-party pole assemblies
Three 3/8"-16 or metric M10 nut
plates
Three 3/8"-16 or metric M10 nut
plates
Pole-mount receptacle; cabinet
optionally available (UMS-SM
subwoofer) with factory installed
threaded end plates for single-
mount configurations with the
UMS-SM U-bracket
15