Installation With Bar Cut-Out; Tools Required; Installing The Cylinder Into The Mortise Lock - Kaba 1546-K5 Operating Manual

Operating Manual
4.3

Installation with bar cut-out

4.3.1

Tools required

4.3.2

Installing the cylinder into the mortise lock

X ≥ 7.5
1
Kaba mechatronic cylinder compact
• Flat head and Phillips screwdriver
1 Door
2 External fitting or external rosette
3 Antenna
ü Mechatronic cylinder compact ready
ü Mortise lock installed
2 3
ü Internal fitting with bar cut-out screwed onto door
1. Align the cylinder cam so that it is parallel to the cylinder bar.
2. Push the cylinder into the mortise lock from the inside.
Note: The antenna (3) must be at least 7.5 mm from the external fitting (2).
3. Tighten the forend locking stud.
4. Check the distance (X) between the inner side and adapter (knob).
Note: Distance (X) must be at least equal to the thickness of the internal fitting.
5. Remove the protection film from the cover of the knob.
ð The cylinder has been installed.
k1evo820 - 201606
Installation
Round profile 17