Cardinal 201 Installation, Technical And Operation Manual page 77

EIP= (Enable Ethernet/IP)
For= (Output Weight as...)
ord= (Output Weight Byte Order)

8400-M117-O1 Rev D
Press the F3/  key to show the current setting. If the setting displayed is
acceptable, press the F3/  key again to save it. Otherwise, use the
F2/ key to toggle to a new setting and then press the F3/  key to save
it. Allowable settings are:
off
Off (Ethernet/IP is Disabled)
on ON (Ethernet/IP is Enabled)
NOTE: If EIP= (Enable Ethernet/IP) is Enabled (on), the
following prompts, Output Weight as... and Output weight byte
order will be active.
Press the F3/  key to show the current setting. If the setting displayed
is acceptable, press the F3/  key again to save it. Otherwise, use the
F2/ key to toggle to a new setting and then press the F3/  key to save
it. Allowable settings are:
fLoAt Output Weight as Float
int Output Weight as Integer
Press the F3/  key to show the current setting. If the setting displayed
is acceptable, press the F3/  key again to save it. Otherwise, use the
F2/ key to toggle to a new setting and then press the F3/  key to save
it. Allowable settings are:
1234
Model 201 Installation & Technical
4321 3412 2143
Page 69