Error And Status Codes - Cardinal 201 Installation, Technical And Operation Manual

Model 201 Installation & Technical

9.2 Error and Status Codes

Page 118
The Model 201 Weight Transmitter is equipped with software that
indicates when an error in the operation takes place. The following lists
the error and status codes displayed by the 201 along with their meaning.
Should you encounter a code, please refer to this list.
Error
Calib Calibration required
Err H The analog input signal is high
Err L The analog input signal is low
oCAP The load on the scale exceeds the capacity of the scale
SrArn SRAM error detected during startup
EEPROM CRC error detected during startup – settings
CALIB
will revert to default
E CAbl Waiting for Ethernet
dHCP Network configured for Dynamic Host Configuration
Protocol
dHCP b During dHCP binding
statiC Network configured for static IP address
P1= First part of IP address (## . # . # . ## - e.g., 90.1.2.68)
P2=
Second part of IP address (## . # . # . ## - e.g.,
P3=
90.1.2.68)
P4=
Third part of IP address (## . # . # . ## - e.g., 90.1.2.68)
Fourth part of IP address (## . # . # . ## - e.g., 90.1.2.68)
USb Running on USB power
boot Boot loader mode
notArE Attempt to select Gross/Net to show Net weight when
there is no tare weight
UnStb Attempt to print with unstable weight
 
Attempt to zero with motion
Error O Attempt to zero with over capacity
Error R Attempt to zero out of range
Error d Too many divisions configured for Legal For Trade
Meaning
8400-M117-O1 Rev D