Serial Port - Cardinal 201 Installation, Technical And Operation Manual

5.6 Serial Port

SEriAl
With SEriAL displayed, press the F3/  key. The display will change to .
Proceed to the  (Serial Port Mode) parameter.
 (Serial Port Mode)
bAUd= (Baud Rate)
DATA= (Data Bits)
8400-M117-O1 Rev D
Press the F3/  key to show the current setting. If the setting displayed is
acceptable, press the F3/  key again to save it. Otherwise, use the
F2/ key to toggle to a new setting and then press the F3/  key to save
it. Allowable settings are:
Rs 232 RS232 (Serial interface uses RS232 protocols)
rS 485 RS485 (Serial interface uses RS485 protocols)
off Off (Serial interface is disabled)
NOTE: If the Serial Port Mode is enable, the following prompts,
Baud Rate, Data bits, Parity, Stop Bits, Weight Mode and Print
from Port will be shown.
Press the F3/  key to show the current setting. If the setting displayed is
acceptable, press the F3/  key again to save it. Otherwise, use the
F2/ key to toggle to a new setting and then press the F3/  key to save
it. Allowable settings are:
1200 = 1200 Baud
9600 = 9600 Baud
57600 = 57,600 Baud 115200 = 115,200 Baud
Press the F3/  key to show the current setting. If the setting displayed
is acceptable, press the F3/  key again to save it. Otherwise, use the
F2/ key to toggle to a new setting and then press the F3/  key to save
it. Allowable settings are:
7 = 7 data bits
Model 201 Installation & Technical
2400 = 2400 Baud
19200 = 19,200 Baud 38400 = 38,400 Baud
8 = 8 data bits
4800 = 4800 Baud
Page 53