RightAngle NewCrank SPLIT WORKSURFACE CRANK HEIGHT ADJUSTABLE WORKSTATION Assembly Instructions

K&A MANUFACTURING
6703 ZINSER ST., SCHOFIELD, WI 54476
PHONE: 800.298.4351 FAX: 866.882.9475
www.raproducts.com
VERSION DATED: 3/6/12
READ ALL THE INSTRUCTIONS BEFORE BEGINNING
DO NOT OPERATE THE UNIT UNTIL IT IS FULLY ASSEMBLED
HEX
DRIVE
WORKSURFACE
SUPPORT
STEPS 1-3
INSTRUCTION # 52639
TOOLS REQUIRED FOR ASSEMBLY:
CORDLESS DRILL
#2 PHILLIPS HEAD DRIVER BIT OR
#2 SQUARE HEAD DRIVER BIT
7/32" HEX HEAD DRIVER BIT OR
ALLEN WRENCH PROVIDED
TAPE MEASURE
LEVEL
2
1
4
NewCrank SPLIT WORKSURFACE CRANK HEIGHT ADJUSTABLE WORKSTATION
ASSEMBLY INSTRUCTIONS:
STEP 1: LAY THE FIXED WORKSURFACE 1 ON A PROTECTED SURFACE WITH THE
PILOT HOLES FACING UP.
STEP 2: PLACE THE LEFT HAND COLUMN ASSEMBLY
CRANK) ON THE WORKSURFACE
THE INNER COLUMN MUST FACE THE CENTER OF THE WORKSTATION. ALIGN
THE HOLES IN THE WORKSURFACE SUPPORT WITH THE PILOT HOLES IN THE WORK-
SURFACE.
STEP 3: INSERT THE END OF THE HEX ROD
HAND COLUMN ASSEMBLY
COLUMN ASSEMBLY
THE HEX ROD INTO THE HEX DRIVE ON THE COLUMN ASSEMBLY. YOU MAY
NEED TO TURN THE CRANK ON THE LEFT HAND COLUMN ASSEMBLY TO ALIGN
THE HEX ROD WITH THE HEX DRIVE. ALIGN THE HOLES IN THE WORKSURFACE
SUPPORT WITH THE PILOT HOLES IN THE WORKSURFACE.
3
ITEM # PART #
1 VARIES NewHeights FIXED WORKSURFACE
2 VARIES NewCrank LEFT HAND COLUMN ASSEMBLY
3 VARIES NewCrank RIGHT HAND COLUMN ASSEMBLY
4 VARIES NewCrank HEX ROD
5 VARIES NewHeights CROSS SUPPORT
6 52477 3/8 INTERIOR TOOTH STAR WASHER
7 52470 3/8-16 x 3/8 BUTTON HEAD SOCKET SCREW
8 800411 NewHeights/HOVER END CAP
9 51708 M5 x 18mm SQ/PH/WSHR HEAD WOOD SCREW
10 50219 NewHeights SWING ARM (300SW)
11 VARIES NewHeights MOVABLE WORKSURFACE
12 52498 7/32" ALLEN WRENCH
HARDWARE QUANTITIES MAY VARY
HARDWARE PACK # 52226
1
AS SHOWN. THE HEX DRIVE AT THE TOP OF
4 INTO THE HEX DRIVE ON THE LEFT
2
AS FAR AS IT WILL GO. PLACE THE RIGHT HAND
3 ON THE WORKSURFACE 1 SLIDING THE OTHER END OF
DESCRIPTION
2 (THE ASSEMBLY WITH THE
QTY.
1
1
1
1
1
4
4
2
16
1
1
1
PAGE 1 OF 2