Table of Contents
Advertisement
7 Dismantling of the fan unit
6.13 Pedestal installation
Install the pedestal of the ES enclosure in a manner that
locates the ventilation gap above the pedestal rail (Figure 6).
Ventilation gap
Figure 6
7 Dismantling of the fan unit
at the fire protection enclosure PRIOELEC EHL/ESL
ATTENTION:
The Following installation works have to be done by a qua-
lified electrician!
1. Disconnect the fan unit from the supply voltage taking
care about VDE 0100 230 V mains connection before
beginning to dismantle. Determine freedom from tension.
WARNING 230 V AC
Dangerous Voltage. Can cause death, heavy injuries and
property damage!
14
Mounting and Operating Instructions Fire-Resistant Cabinet Type US-S ESF30 40071860245 (B) February 2020 www.ceag.de
2. Disconnect and remove the temperature sensor.
Loosen the cable connection at the contacts of the termi-
nal block. Pull out the temperature-sensor with cable out
of the enclosure.
3. dismantling the fan unit:
Hold on the fan unit with one hand and loosen the two
screws (4,5 x 55 mm) at the fan with the other hand.
4. Remove the fan unit EBEL-VENT-L230 and the supply-
cable from the enclosure.
Advertisement
Table of Contents
