Connecting Several Devices; Connecting Mains Cable - Targa LT 4010 Owner's Manual And Service Information

LT 4010
1.
Plug the cable (VGA or HDMI) into the output socket of the graphic board.
2.
Plug the other end of the cable into the corresponding socket ([RGB], [HDMI 1] or
[HDMI 2]) on the television set.
3.
Plug the audio cable with the jack plug into the socket [PC SOUND] and the
output socket of the sound board.
4.
Set the sound source to PC. See chapter "Sound Settings" on page 27.
In some cases you need to use an adapter. The adapter is not included in the
delivery.
Adjust the settings of the computer image according to the settings of the
television image. See "Settings" on page 21.

Connecting several Devices

You can use the described connections and external devices parallel. For
information on how to select a device for display, refer to chapter: "Select source"
on page 46 and "Select Signal Source for PIP" on page 47.

Connecting Mains Cable

1.
Plug one end of the mains cable into the mains socket on the television set.
In case the television set does not receive any signal, adapt the
output of the computer. For information on setting up the computer,
refer to the manual of the computer. The optimum resolution for the
television set is 1360 x 768 Pixel
Connections and Start of Operation
17