Connecting To Component Video - Targa LT 4010 Owner's Manual And Service Information

LT 4010
If your external device provides RGB, S-Video and Video (CVBS), use the
SCART 1 socket. If your external device provides only S-Video and Video
(CVBS), use the SCART 2 socket. You can use both sockets parallel.

Connecting to Component Video

Component video or Y, Pb, Pr is an analogue connection that transmits images
of signal sources such as DVD-devices in a very good quality. For this the
brightness information is transmitted on one line and the colour information on the
other two. If you use this connection, you must transmit the sound separately. For
this, use the audio sockets on the respective component input.
Y, Pb, PR are also suitable to transmit progressive scan or HDTV signals to the
TV set.
1.
Plug the component cable according to the colours (green, red, blue) into the
sockets [Y], [Pb] and [Pr] of the input COMPONENT 1 or COMPONENT 2 and the
output sockets of the external device.
2.
Plug the audio cable into the socket [AUDIO R/L] of the Component input used
and connect them with the output sockets of the external device.
If your external device only provides a Mono-output, use the left channel [MONO]
for the audio input.
For information on the supported signals refer to chapter "Technical
specifications" on page 55.
Connections and Start of Operation
11