Assembly - Husqvarna 350BT Operator's Manual

Introduction
WARNING: Read and understand the safety
chapter before you assemble the product.
To assemble the blower pipe and the
control handle on the product
1. Attach the flexible hose (A) to the pipe angle and the
control pipe (B) with the clamps (C) and (D).
C
Note: Lubricate the control pipe and the flexible hose
to make them more easy to assemble.
2. Attach the handle holder (E) to the control pipe. Align
the handle holder with the flange on the control pipe.
3. Adjust the position and angle of the control handle to
a safe and correct work position. Tighten the knob.
6

Assembly

A D
B
E
4. Attach the cable to the flexible hose with the cable
clamp.
5. Attach the intermediate pipe to the control pipe.
Note: If it is a requirement to use a longer circular
blower pipe, an extended intermediate pipe is
available.
6. Attach the blower nozzle to the intermediate pipe.
Note: The blower nozzle can only be installed on the
intermediate pipe.
To assemble the handlebar (optional
accessory)
1. Disassemble the intermediate pipe.
2. Remove the knob from the holder and push the
holder onto the control pipe.
3. Install the handlebar and the knob. Tighten the knob.
1246 - 002 - 24.03.2020