Husqvarna 350BT Operator's Manual page 8

Hide thumbs Also See for 350BT:
Table of Contents

Advertisement

Available languages
  • EN

Available languages

  • ENGLISH, page 1
2. Add the full quantity of oil.
3. Shake the fuel mixture.
4. Add the remaining quantity of gasoline to the
container.
5. Carefully shake the fuel mixture.
CAUTION: Do not mix fuel for more than 1
month at a time.
To fill the fuel tank
WARNING: Obey the procedure that follows
for your safety.
1. Stop the engine and let the engine become cool.
2. Clean the area around the fuel tank cap.
3. Shake the container and make sure that the fuel is
fully mixed.
4. Remove the fuel tank cap slowly to release the
pressure.
5. Fill the fuel tank.
CAUTION: Make sure that there is not
too much fuel in the fuel tank. The fuel
expands when it becomes hot.
6. Tighten the fuel tank cap carefully.
7. Clean fuel spillage on and around the product.
8. Move the product 3 m/10 ft or more away from the
refueling area and fuel source before you start the
engine.
Note: To see where the fuel tank is on your product,
Product overview on page 2 .
refer to
8
To start the product
1. If the engine is cold, push the choke lever to the
closed choke position. Refer to
product on page 3 .
2. Push the air purge bulb again and again until fuel
starts to fill the air purge bulb. It is not necessary to
fill the air purge bulb fully.
3. Push the start/stop switch with throttle control to the
1/3 speed position. Refer to
control/stop switch on page 9 .
4. Put the product on a flat surface on the ground.
5. Hold the product with the left hand.
CAUTION: Do not use your feet to hold
the product.
6. Pull the starter rope handle slowly until resistance
occurs.
7. Pull the starter rope handle quickly with the right
hand. Pull the starter rope handle again and again
until the engine starts.
Note: Do not pull the starter rope handle to full
extension and do not let go of the starter rope
handle.
8. If the engine is cold, push the choke lever to the
open choke position gradually until the choke lever
stops.
9. If the engine is cold, let the engine operate for 2-3
minutes to become warm before operation.
Symbols on the
To operate the throttle
1246 - 002 - 24.03.2020

Hide quick links:

Advertisement

Table of Contents
loading

Table of Contents