Assembly - Husqvarna 350iB Operator's Manual

• Keep all cables and extension leads away
from water, oil and sharp edges. Make sure
that the cable is not caught between doors,
fences or similar.
• Do not use the battery charger near
flammable materials or materials that can
cause corrosion. Make sure that the battery
charger is not covered. Pull out the plug to the
battery charger if there is smoke or fire.
• Only charge the battery indoors in a location
with good airflow and away from sunlight.
Do not charge the battery outdoors. Do not
charge the battery in wet conditions.
• Only use the battery charger where the
temperature is between 5 °C (41 °F) and
40 °C (104 °F). Use the charger in an
environment which has a good airflow, dry
and free from dust.
• Do not put objects into the cooling slots of the
battery charger.
• Do not connect the battery charger terminals
to metal objects as this can short circuit the
battery charger.
• Use approved wall sockets that are not
damaged.
Safety instructions for maintenance
WARNING:
warning instructions that follow before
you do maintenance on the product.
Introduction
This section describes how to assemble and
adjust the product.
WARNING:
the product, read the safety chapter
and the assembly instructions.
To assemble the blower tubes
Note:
Apply water-based lubricant on the end of
the tubes to make assembly easier.
10
Read the

Assembly

Before you assemble
• Remove the battery before you do
maintenance, other checks or assemble the
product.
• The operator must only do the maintenance
and servicing shown in this operator's
manual. Speak to your servicing dealer
for maintenance and servicing of a larger
extension.
• Keep all nuts, bolts and screws tight to be
sure the product is in safe working condition.
• Replace worn or damaged parts.
• If you do not do maintenance, it decreases the
life cycle of the product and increases the risk
of accidents.
• Special training is necessary for all servicing
and repair work, especially for the safety
devices on the product. If not all checks
in this operator's manual are approved after
maintenance, speak to your servicing dealer.
We guarantee that there are professional
repairs and servicing available for your
product.
• Only use original spare parts.
SAVE THESE
INSTRUCTIONS
• Attach the lower tube to the upper tube until
the tab (B) goes into the hole (A). Make sure
that the lower tube and the upper tube are
locked together.
A
B
1776 - 002 - 09.03.2022