Table of Contents
Advertisement
Available languages
Available languages
let the product dry. Remove unwanted fuel from the
product.
•
If you spill fuel on your clothing, change clothing
immediately.
•
Do not get fuel on your body, it can cause injury. If
you get fuel on your body, use a soap and water to
remove the fuel.
•
Do not start the engine if you spill oil or fuel on the
product or on your body.
•
Do not start the product if the engine has a leak.
Examine the engine for leaks regularly.
•
Be careful with fuel. Fuel is flammable and the fumes
are explosive and can cause injuries or death.
•
Do not breathe in the fuel fumes, it can cause injury.
Make sure that there is sufficient airflow.
•
Do not smoke near the fuel or the engine.
•
Do not put warm objects near the fuel or the engine.
•
Do not add the fuel when the engine is on.
•
Make sure that the engine is cool before you refuel.
•
Before you refuel, open the fuel tank cap slowly and
release the pressure carefully.
•
Make sure there are sufficient airflow when refueling
and mixing fuel (petrol and two-stroke oil) or draining
the fuel tank.
•
Fuel and fuel vapor are highly flammable and can
cause serious injury when inhaled or allowed to
come into contact with the skin. For this reason,
observe caution when handling fuel and make sure
there is sufficient airflow.
•
Tighten the fuel tank cap carefully or a fire can
occur.
•
Move the product at a minimum of 3 m (10 ft) from
the position where you filled the tank before a start.
Introduction
WARNING:
safety chapter before you assemble the
product.
8
Assembly
Read and understand the
•
Do not put too much fuel in the fuel tank.
•
Make sure that a leak cannot occur when you move
the product or fuel container.
•
Do not put the product or a fuel container where
there is an open flame, spark or pilot light. Make
sure that the storage area does not contain an open
flame.
•
Only use approved containers when you move the
fuel or put the fuel into storage.
•
Empty the fuel tank before long-term storage. Obey
the local law on where to dispose fuel.
•
Clean the product before long-term storage.
•
Remove the spark plug cap before you put the
product into storage to make sure that the engine
does not start accidentally.
Safety instructions for maintenance
WARNING:
instructions that follow before you use the
product.
•
Your warranty may not cover damage or liability
caused by the use of non-authorized accessories or
replacement parts.
•
The inside of the muffler contains chemicals that
may be carcinogenic. Avoid contact with these
elements in the event of a damaged muffler.
•
Stop the engine before assembling or dismantling
accessories or other parts.
•
Check that the thick round pin in the clamp is
inserted in the strap. If it is inserted incorrectly it may
lead to personal injury.
To assemble the tube and handle on
the product
J
H
I
B
1. Attach the control handle (H) to the control pipe (B)
and tighten the two screws (I).
2. Use the clamps (C) to attach the flexible hose (A) to
the control pipe (B) and to the pipe angle (J).
Read the warning
C
A
C
E
F
G
D
1913 - 001 - 16.08.2022
Advertisement
Chapters
Table of Contents
