Assembly - Husqvarna 360BT Operator's Manual

Introduction
WARNING:
the safety chapter before you assemble
the product.
To assemble the blower pipe and the
control handle on the product
1. Attach the flexible hose (A) to the pipe angle and
the control pipe (B) with the clamps (C) and (D).
C
Note:
Lubricate the control pipe and the
flexible hose to make them more easy to
assemble.
2. Attach the handle holder (E) to the control pipe.
Align the handle holder with the flange on the
control pipe.
3. Adjust the position and angle of the control
handle to a safe and correct work position.
Tighten the knob.
4. Attach the cable to the flexible hose with the
cable clamp.
1967 - 001 - 20.01.2023

Assembly

Read and understand
A D
B
E
5. Attach the intermediate pipe to the control pipe.
Note:
If it is a requirement to use a longer
circular blower pipe, an extended intermediate
pipe is available.
6. Attach the blower nozzle to the intermediate
pipe.
Note:
The blower nozzle can only be installed
on the intermediate pipe.
To assemble the handlebar (optional
accessory)
1. Disassemble the intermediate pipe.
2. Remove the knob from the holder and push the
holder onto the control pipe.
3. Install the handlebar and the knob. Tighten the
knob.
4. Assemble the intermediate pipe.
To assemble the flat nozzle (optional
accessory)
The flat nozzle gives a higher air speed than the
blower nozzle.
7